Home > Microphones > Hanging Microphones >

Audix ADX40WHC WHITE Hypercardioid Condenser Hanging Choir Mic

AUDIX ADX40WHC Hypercardioid Hanging Choir Microphone, White

List Price: $265.00
PAS DEAL $229.00
You save $36.00!
You'll earn 229 points
Mfg Model : ADX40WHC
UPC: 687471061213

Availability: Usually Ships in 1 to 2 Business Days
Product Code : ADX40W-HC


AUdix ADX40WHC WHITE Hypercardioid Condenser Hanging Choir Micinline>

The ADX-40 is a miniature pre-polarized condenser microphone designed to hang from an overhead position for applications in professional live sound, music, and broadcast. Available with a choice of three optional interchangeable microphone capsules (cardioid, omni, and hypercardioid), the ADX-40 is most commonly used for plays, theatrical productions, choirs, group vocals, and room ambience miking. With a smooth uniform response over a frequency range of 40-20k Hz, the ADX-40 provides a warm, rich sound not typical of microphones this size. It is machined from solid brass and comes in a non-reflective black finish. Supplied with an attached 30' cable, the ADX-40 operates on phantom power (9-52volts) with the preamp module provided (APS-910). If phantom power is not available, there is an optional power supply (APS-911) that operates in phantom or battery mode with bass roll-off and on-off switches. Low noise electronic circuitry, low impedance, and balanced output allow interference-free performance even with long cable runs.


  • Choirs, musical groups
  • School plays, theatrical productions
  • Room ambience microphone for recording or broadcast
  • Orchestra
  • Transducer Type: Condenser (pre-polarized)
  • Frequency Response: Cardioid/Hypercardioid 40Hz - 20kHz / Omni 20 - 18kHz
  • Polar Pattern: cardioid, omni, hypercardioid depending on choice of capsule
  • Output Impedance: 250 Ohms balanced
  • Open Circuit Sensitivity - Cardioid / Hypercardioid: 5.2 mV / Omnidirectional: 4.1 mV
  • Equivalent Noise Level: 29 dB (A weighted)
  • Signal to Noise Ratio: 65 dB (ref 1k @ 1 Pascal)
  • Power Requirements: 9 - 52v phantom
  • Maximum SPL: 130dB
  • Cable/Connector: Shielded 30' (14m) terminating to a miniature 3 pin Switchcraft XLR connector (TA3-f)
  • Polarity: Positive voltage on pin 2 relative to pin 3 of output XLR connector
  • Housing: Machined Brass
  • Weight 4 oz/110 grams (not including cable)

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Microphones > Hanging Microphones