 | Made in the USA
Support American made products
Our future depends on it |
|
The Ashly PE-3800 is a lightweight (24 lbs.), high-power,
high-efficiency stereo rackmount power amplifier offering 1100 Watts of power
output per side at 8 Ohms and a switching power supply.
The PE-3800 incorporates cutting-edge multi-amplifier network technology,
enabling remote control and operation of the unit by a computer via the supplied
Protea Software(TM) CD. The connection is of a standard Cat-5 Ethernet type,
unencumbered by any proprietary hardware.
An optional DSP card is available for the PE-3800 as well, offering 24-bit
digital connectivity and a large library of EQ and Dynamics processors along
with sine wave, pink and white noise generators.
Key Features
-
2RU 24 lb. lightweight rackmount stereo power amplifier with remote network
control capability and 1100 Watts per side power output at 8 Ohms
-
Stereo, Bridge Mono and Parallel Mono Operation
-
Built-in Ethernet port using supplied Protea Software(TM) offers remote user
access to input attenuation, channel mute, channel polarity, input level, output
voltage, output current, clipping, temperature, and power on/off
-
Standard Cat-5 Ethernet connector, fully compatible with standard 100MB
Ethernet hardware
-
2-stage high-efficiency switched mode power supply with high power-to-weight
ratio
-
Ultra-quiet fan-cooled operation
-
On-board analog processing with selectable subsonic filter, selectable
clip-limiter and an input-sensitivity selector optimizing the amplifier for load
requirements
-
Comprehensive amplifier protection circuitry includes: inrush current
limitation, temperature monitoring heat-sinks, output DC protection, power
transistor SOA protection, output over-current protection and mains fuses
protection
-
Full set of front-panel LED indicators with per channel clip, temperature and
output current visual monitoring; Overall power, standby, protect, bridged mono,
parallel mono and communications LED's
-
XLR/1/4" Combo and Euroblock input connectors with XLR loop-through, Speakon
Outputs
-
Optional DSP card with 24-bit AD/DA, analog and digital(AES3) inputs and DSP
processing library with Graphic, Parametric, Notch and Shelving Equalization and
High-, Low- and All-Pass Filters with up to 48dB/Octave slopes
-
Additional DSP card dynamics and signal processing includes Delay,
Compressor/Limiter, Gate, Gain, Signal Generators (sinewave, white and pink
noise) and Matrix Routing
Specifications:
| Power Rating |
Stereo @ 8 Ohms: 1100W per Ch.
Stereo @ 4 Ohms: 1900W per
Ch.
Stereo @ 2 Ohms: 1500W per Ch.
Mono Bridge @ 8 Ohms: 3800W per
Ch.
Mono Bridge @ 4 ohms: 3000W per Ch.
Parallel Mono @ 2 Ohms: 3800W per
Ch. |
| Damping Factor |
>400, 8-Ohm load, <1kHz |
| Input Sensitivity |
1.5V |
| Input Impedance |
20 kOhms, Balanced |
| Gain |
Selectable 26dB, 32dB or 1.5V sens. |
| Frequency Response |
20 Hz - 20 kHz, 0.15dB |
| Signal-to-Noise Ratio |
>112dB, 20Hz - 20kHz
unweighted |
| Total Harmonic Distortion (THD) |
<0.01% (8-Ohm load, 10dB below rated power, 20Hz -
10kHz |
| Input Connections |
2 x 3-pin XLR Female/1/4" TRS Combo
1 x Ch.1,2 Euroblock In
1 x Remote
Level/Standby Euroblock
1 x 3-pin XLR Male Loop-Through
1 x Cat-5
Link/Data Port |
| Output Connectors |
2 x Speakon |
| Controls Front Panel |
1 Power Switch
2 x Gain Control Knobs |
| Controls (Rear) |
1 x Ground Switch
2 x Ch.1,2 3-position HPF Switches
1 x 3-position
Clip Limiter Switch
1 x 3-position Gain Switch
1 x Bridge/Stereo/Parallel
Mode Switch |
| Indicators |
1 x Blue Power LED
1 x Yellow Standby LED
1 x Red Protect LED
2 x
Green Bridge/Parallel Mono Mode LED's
1 x Green Comm. LED
2 x Red
Clip/Mute LED's
2 x Yellow -6 Level LED's
4 x Green -12/-18 Level
LED's
2 x Yellow Temp. LED's
2 x Green Current LED's |
| Cooling |
Temperature-dependent speed-controlled axial fan, front to back air
flow |
| Power Consumption |
1220W (1/8 Power Pink Noise @ 4 Ohm)
Typical Current:
Idle:
2.8A
@8 Ohms: 14.6A
@4 Ohms:
22.6A |
| Dimensions |
19 x 3.5 x 15.5" (483 x 88.9 x 394mm) |
| Weight |
24 lb (10.9 kg) |
| Specialties |
Lightweight Power Amplifier with Switching Power
Supply
Network Remote Control Software with Standard Ethernet
Connectivity
Optional DSP
Cards |
Click here for more information |
