| The EQ Sections
HP - The
High Pass section is a sharp filter that cuts all content below
one of eight pre-selected frequencies. We call this particular
filter a "colored" filter since it is very steep and
has a special shape that prevents thinning out frequencies just
above the "cutoff" frequency. The corner frequency is
indicated by LEDs that glow softly when the section is bypassed,
and brightly when the section is engaged. As with all the EQ
sections in the Lil FrEQ, there is a dedicated bypass switch.
High and Low Shelving - These are very
similar to your standard "Tone Controls", but
extremely high performance, providing exceptionally smooth boost
and cut on the "bass" and "treble"
frequencies.
Parametric EQ Sections - There are four
sections of fully parametric EQ... possibly the cleanest
parametric EQ section ever produced- operating below .0007% THD
(Total Harmonic Distortion) at extremely high audio levels. Try
finding those specs anywhere else!
Dynamic EQ Section - The DS section
combines filters with a compressor-like circuit that can help
contain and control excessive high frequency content such as
sibilants, especially in the absence of other lower frequency
content. There are two modes of operation, with threshold control
as well as a frequency select control. There are four LEDs that
indicate the amount of Gain Reduction: -1.5dB, -8dB, -14dB,
-24dB. The DS section provides the highest performance, easiest
to use, and most natural De-esser ever built, as well as a one of
a kind, soft knee High Frequency Limiter. You will love it!
Specifications
- Freq. Response
5 Hz to 140 kHz on transformerless inputs and outputs.
Transformer Output response is 10 Hz to 110 kHz .
- Dynamic Range
120 dB from maximum output (.1% clipping) to minimum output.
Greater than 110 dB signal to noise.
- Distortion
Ranges between .00056% and .005% depending on mode and settings.
DS section has THD < .005%.
- DC coupled
Input and Outputs and one transformer coupled Output
High quality audio caps used internally.
- Dynamic Time Constants
Attack is approximately .5 mS. Release .04 sec, fixed
internally.
Click here for more information |
