Mystery BB1000 Back Box for FMCA1000 6" x 6"x 6"

Notes:

As floor box may be subjected to long-term traffic and occasional heavy loads, it is strongly recommend that firm attachment of the backbox to the framing be made with four (4) each #8 or larger screws fastened on at least two (2) planes (sides), minimum. Nails will not offer long term installation integrity as they work loose over a very short time period. Additional blocking or framing may be required to provide solid attachment of the backbox as per Notes & details herein.

When placement adjacent to structural framing is not possible, blocking must be placed at the sides of the hole that is cut for the backbox. Blocking of 1" x 2" minimum must be screw attached to the floor decking on each side of the hole. Blocking should be a few inches longer than the dimension of the hole on the two sides that are parallel to the hinge of the FMCA unit. Feed each strip down into the cutout hole and pull it up against the underside of the floor. Place #8 or larger flat head wood screws on 3" centers thru the floor 1" back from edge of hole along each side into the blocking. Secure backbox to blocking as above. When FMCA unit is installed, the floor will be clamped securely between the FMCA cover and the blocking strip.

Fig.2: Wood Floor

Fig.3: Concrete Floor

The Mystery Electronics FMCA Series are not recommended for unprotected outdoor or indoor wet, damp or severe weather locations. Certain local building codes may require that the backbox be coated with pitch for below ground applications. This can be done by spraying the outer surface of the box with automotive undercoating material available in spray cans from most auto parts or discount department stores (Wal-Mart, etc.). It is additionally advised that the contractor close all open cracks with packaging tape, duct tape, or similar to prevent concrete slurry from seeping into backbox during the concrete pour.

To automatically adjust for proper backbox depth before concrete is poured, attach a piece of �" plywood of the same dimension as the backbox to the top of the box with screws. Screed concrete flush to the top of the plywood. This will result in the box being at the proper depth of �" below the finished concrete surface as per Notes & details herein. Adjust depth accordingly when composite floor structures and materials are built over concrete.

Bringing the power conduit into the bottom of the backbox should be avoided if possible, as extreme care is needed to assure the proper clearances for the FMCA unit are maintained. When this is the only alternative, the straight flex connector must be replaced with a 90-degree flex connector and the aforementioned �" rigid coupling must be cut down to �" in length to provide proper clearance for the FMCA unit. The short threaded ring in the center of a �" �Ericson� (Appleton EC50 or equal) three piece coupling or a � x � reducing bushing can usually be used as a substitute.A �" conduit for the power circuit is recommended. A �" conduit can be allowed, provided a � x � male adapter is used to mate the power conduit to the backbox. This will eliminate extensive field modification of the R option during installation of the FMCA unit.

Leave 24" of the power circuit conductors in the backbox at rough-in to allow connection to R option pigtail.